7-20 Structure and Assembly/Disassembly
Figure 7-23 Disassemble the Main Board Assembly (2)
5. When removing panhead screws with washers (4 M3X6) used to fix the CPU module, you
can take out the CPU module.
Figure 7-24 Disassemble the CPU module
6. After removing the CPU module, Remove panhead screws with washers (12 M3X6) fixed on
the main unit box, you can take off the board. Remove the HDD in back of the board, the left
is main board.
Figure 7-25 Disassemble the Main Board
You can’t draw out the CPU module abruptly, but you would pull it out after
loosening the board from the left/right side to avoid damaging the main board
FPGA.
After replacing the CPU module, key file must be generated once again according
to the new MAC address and written into HDD of the machine. Or else, the
configuration function of the product will be lost.
To Next Page
Loading...
