Minelab F3Ci - Page 14

F3Ci Service Manual
_______________________________________________________________________________________________________________________
14
• Turn the detector over onto its left side with speaker grill uppermost.
• Using the 3mm hex key driver, remove all eight screws from the detector body.
Note
There are four 35mm long screws and four 20mm long screws.
•
Using a T20 Torx (star) driver unscrew all four screws (three 35mm and one 20mm)
from the right side of the detector.
•
Figure 10: Disconnecting Coil Plug and Removing Screws
Fig
ure 12
: Removing Four Torx Screws
Figure 11: Removing Eight Screws (Allen Key)