Minelab F3Ci - Operating Procedures; Operating Procedures Introduction

F3Ci Service Manual
_______________________________________________________________________________________________________________________
24
• Remove the PCB screw from the main PCB, using a 2.5mm hex key driver.
• Disconnect the battery connector from the main PCB.
• Slide the coil socket out of the detector body.
• Disconnect the Earset cable assembly (internal) from the main PCB. Figure 33.
• Disconnect the handle wiring loom from the main PCB.
• Disconnect the vibration motor connector from the main PCB.
Figure 32: PCB Screw, Battery Connector and Coil Socket
Battery Connector
PCB Screw
Coil Socket
Figure 31: Removing the Coil Connector Nut (18mm)