Minelab F3Ci - Standard Operating Procedure; STEP 1 Switch ON

F3Ci Service Manual
_______________________________________________________________________________________________________________________
25
• Identify the ribbon cable connector on the main PCB which connects to the switches.
• Lift open the locking bails on the ribbon cable connector this allows the ribbon cable
to be removed and inserted.
• Gently slide the ribbon cable out of the connector.
•
Slide the main PCB away from the battery assembly until the ends of the main PCB
disengage from the slots in the detector body near the battery compartment.
Figure 33: Disconnect Connectors on main PCB
Figure 34: Disconnect the Ribbon Cable
Earset Cable
A
ssembly
internal
Wiring Loom Handle
Vibration Motor
Connector
1. Identify Ribbon Cable
3. Remove Ribbon Cable
2. Open Locking Bail