F3Ci Service Manual
_______________________________________________________________________________________________________________________
40
•
Thread the coil cable through the detector hinge and align the coil connectors.
Tighten coil connector.
•
Fit coil cable into cable router then replace the hinge cover.
•
Check the latch and spring are connected as shown in Figure 67. If the latch and
spring have become disconnected they must be reconnected. It is possible to
reattach the eyelet of the spring to the pin of the latch hinge through the opening
under the hinge cover. Alternately the detector body can be opened to reattach the
spring to the latch.
Figure 65: Fit cap shaft and screws
To Next Page
Loading...
Need help?
General
