Power (On/Off)
Figure 4.2
This switch turns the power from the battery to the detector On and Off.
NOTE Always switch the detector Off before connecting or
disconnecting the coil or battery pack and when not in use.
CONTROL FUNCTIONS
Figure 4.1 Rear Panel
There are two control panels: the rear panel and the front panel.
CONTROL FUNCTIONS
Rear Panel Figure 4.1
Figure 4.2 Power (On/Off) switch
Power
19
4
CONTROLS
Off
On
P0518-A
Smart Point - A quality initiative from Minelab Electronics
The Smart Point is an intuitive new feature of the GP 3000. It is primarily a diagnostic/test port that ensures that your
detector is operating at peak performance before it leaves the factory. Smart Point also allows Authorized Minelab
Service Engineers worldwide to service and test your machine to ensure consistant and maximum performance at all
times. For service information please contact your local Authorized Dealer.
OTE Do not attempt to open the Smart Point as doing so may damage your detector and void your
warranty.
NOTE
To Next Page
Loading...
