TROUBLESHOOTING
Use the following table to check for suggested solutions to problems.
No sound Turn Threshold control fully clockwise.
Turn Volume control clockwise.
Check power cable and connections.
Check headphones.
Check battery.
Threshold but no target signal Try testing different coils.
Random noises Check for other detectors interfering.
Retune using Tuning button.
Charge the battery.
Set Coil switch to Cancel.
Ground balance again.
Check for thunderstorm build-up.
Battery will not charge using vehicle Check for power to cigarette lighter socket in vehicle.
charger Check 10 amp fuse in charger plug.
Battery not holding charge Try alternative charger.
Check power cable.
Very noisy threshold Check for interference and re-tune.
Try detecting in a different location.
Set Coil switch to Cancel.
FAULT SUGGESTION
If you need to return your detector to Minelab for service, please supply as many details as possible about
the fault. This will enable our service engineers to rectify the fault quickly and efficiently.
Return the detector in a cardboard box for protection along with the Service Repair Form supplied in this manual.
Please supply your name, address and phone number along with purchase date and serial number when
sending detector parts for repair.
TROUBLESHOOTING
Table 7.2 Troubleshooting
51
USER INFO
7
To Next Page
Loading...
