QUICK START INSTRUCTIONS (EASY REFERENCE)
easy reference
STEP 1 Set the Coil switch to Double D.
STEP 2 Set Soil switch to N (Normal).
STEP 3 Set Balance switch to Fixed.
STEP 4 Set Iron Discriminate switch to All Metals.
STEP 5 Set Boost to N (Normal) for general detecting.
STEP 6 Set Volume to maximum and Signal to 2 o’clock.
STEP 7 Turn Power Switch on.
STEP 8 Adjust the Threshold control so that a faint sound is heard through
the headphones.
STEP 9 Adjust the Threshold Tone to suit your hearing.
STEP 10 To tune the detector, hold at waist height with the shaft horizontal.
Keep the coil vertical.
STEP 11 Slowly move the coil around your body through a half-circle until
the noise from the interference is loudest.
STEP 12 Hold this position, keep the coil motionless and push the Tune switch
once to start the tuning function.
STEP 13 Tuning takes approximately 60 seconds. A series of 3 beeps will
indicate that the optimum frequency has been selected.
STEP 14 For Discrimination, change the Iron Discriminateswitch to Disc
and set Level Adjust to the middle of its range.
STEP 15 Set the Ground Balance by moving the coil up and down. While coil
is in motion, change Balance switch from Fixed to Tracking.
STEP 16 Once Ground Balalnce has been achieved switch back to Fixed.
STEP 17 The detector is now ready for operation.
QUICK START INSTRUCTIONS
28
OPERATION
5
To Next Page
Loading...
