Minelab GP 3000 - Complete Assembly Instructions

You will need to assemble the GP 3000 from
all the various components, so we have provided you
with detailed assembly instructions.
Assembling and fitting the armrest
Figure 2.3, refer also Figure 2.2
STEP 1 Place the two armrest halves (11) on either side of the upper
shaft (8) and ensure that the bolt holes are aligned.
STEP 2 Slide the two nylon bolts (12) through the bolt holes and screw
the nylon wing nuts (13) onto the bolts by a couple of turns.
STEP 3 Slide the ‘T’ section on top of the control box (10) into the
armrest with the battery plug at the rear. Tighten the nylon
wing nuts by hand.
STEP 4 Attach the armrest straps (14) using the press studs on both
sides of the arm rest.
STEP 5 Push the armrest straps (14) through the slots in the neoprene
armrest cover (15) and then push the cover over the armrest
(11).
COMPLETE ASSEMBLY INSTRUCTIONS
COMPLETE ASSEMBLY INSTRUCTIONS
Figure 2.3 Armrest assembly
8
ASSEMBLY
2
P0511-B
Nylon Bolts (12)
Armrest Parts (11)
Nylon Nuts (13)