Minelab VANQUISH 540 User Manual

9
CONTENTS
Beep!
Beep!
Pinpoint
LOCATE A TARGET MANUALLY
It is possible to locate a target successfully without using
Pinpoint, however this requires practice� This method may be
required when a desirable target is surrounded by trash�
1� Sweep the coil slowly across the target location keeping
the coil parallel to the ground�
2� Locate the centre of the target by listening for the loudest
target signal response�
3� Make a mental note of the position, or mark a line on the
soil with your shoe or a digging tool�
4� Move to one side so that you can pass the coil over the
target at right angles to your initial direction�
5� Repeat steps 1 and 3 from your new position� The target is
located where the two imaginary lines cross�
Beep!
Beep!
Make a line where the
strongest signal is heard�
Stand at right‑angles to
your initial position and
repeat�
The intersection of the
two lines marks the exact
location of the target�
1‑3
4‑5

Minelab VANQUISH 540 Specifications

General

Technology	Multi-IQ
Search Modes	Coin, Relic, Jewelry, Custom, All Metal
Discrimination Segments	25
Sensitivity Levels	10
Volume Levels	10
Audio Tones	5
Bluetooth	Yes
Pinpoint Mode	Yes
Weight	1.3 kg
Waterproof	Coil only (up to 1 meter)
Battery Type	4 x AA
Searchcoil	10" x 7" Double-D
Audio Output	Built-in speaker
Display	LCD
Length	76 cm - 145 cm (30" - 57")
Iron Bias	High