12
PERMANENTLY CONNECTING THE CONTROL BOX
While the X-TERRA control box is designed
to be easily removable for packing and
transport, Minelab have made an option
available to permanently attach the control
box to the handle.
Remove the small circular rubber insert in
the top right-hand side of the handle.
Insert the screw provided into the hole and
tighten using a Phillips screwdriver.
Store the rubber insert in a safe place in
case you wish to reuse it in the future.
Remember to remove this screw before
attempting to disconnect the control box
from the handle. Failure to do this may
result in damage occurring.
If this option is not used, then the rubber
insert may be glued in place using a
silicone sealant or other suitable adhesive.
To Next Page
Loading...
