Problem 1:No Display
6
16
Trouble Shooting Guide
Check:If the cable is broken
Check:Is there any data in USB mode
Check:If the screen needs to be replaced
Problem 2:Every time when installing
a new tip, the temperature status display
random numbers
Means the machine is checking status,which is
normal
Problem 3:Soldering iron restart
automatically
Check 1:Is it properly plugged into the power source?
Check 2:Is the voltage too low?
(need to be set up in the config file)
Problem 4:Soldering iron is heating up
and cooling down simultaneously
Check 1:Is the tip first time in use?
Check 2:Is the power cord in loose or defective contact?
Check 3:Is the tip overheating?
Set the temperature in appropriate level
Check 4:Is the soldering iron clean?
refer to "Soldering iron tip maintenance"
Problem 5:OLED shows "Warning!"
Check 1:Is the TS100 overheating?
Is TS100 temperature higher than the maximun
operation temperature
When temperature is lower than maximum operation
temperature, the warning sign will disappear and it will
return to operation mode
To Next Page
Loading...
Need help?
General