To Next Page
S
Stephen KerrAug 19, 2025
Why is the audio output so low on my miniDSP Recording Equipment?
Why is the audio output so low on my miniDSP Recording Equipment?
General| Input Channels | 2 |
|---|---|
| Output Channels | 4 |
| Sample Rate | Up to 96 kHz |
| Bit Depth | 24-bit |
| Digital Signal Processing | Yes |
| Weight | 0.5 kg |
| DSP Resolution | 32-bit floating point |
| THD+N | <0.005% |
| USB Audio | Yes |
| Signal to Noise Ratio | > 100 dB |
| Dirac Live | Yes |
| USB Audio Interface | Yes |
| Room Correction | Yes |
| Compatibility | Windows, macOS |
| Frequency Response | 20 Hz - 20 kHz |
| Digital Input | Toslink (optical) |
| Input Type | RCA (unbalanced), Toslink (optical) |
Specifies minimum hardware and operating system requirements for configuring the DDRC-24 audio processor.
Guidelines for loudspeaker/microphone positioning and required connections for acoustic measurements.
Procedures for executing acoustic measurements, managing listening environments, and saving projects.
Guides on creating, editing, and adjusting the desired in-room frequency response target curve.
Common problems and solutions for the DDRC-24 plugin and Dirac Live calibration software.
