Minolta EP1030 - Service Mode: Display Functions; Counter Display Procedure; Display Function Details

1159SBS0503A
5-3. Counter Display Procedure
<Display Procedure>
1. Hold down the Clear/Stop Key for 3 sec. ~ The Total Counter count appears.
2. Hold down the Clear/Stop Key for another 3sec. - The IU Counter or CP Counter appears.
«Display Example>
The counter reading is shown on the Display Panel in the following order.
© Total Counter
(Example : 1234)
» [et] 0-@)-0-@-O-@-O-
Note: The IU Counter count Is displayed when “0” is set for “c2” and CP Counter counter is displayed
when “1” is set for “c2”.
4
S-8
1159SBS0804A
5-4. Setting in the Service Mode
1159SBS050401A
1. Display
© This function tests for display of the warming-up time, current {U Counter, previous !U Counter, and the
control panel.
<Setting Procedure>
1. Select the Display mode. (“d0” appears on the Display Panel.)
2. Select the function to be checked or set using the Copy Quantity and Zoom Key © and press the
Start Key. :
3. Press the Clear/Stop Key to stop the display sequence.
<Leaving the Function>
© Select the next Display subfunction using the Copy Quantity and Zoom Key Dor press the Clear/Stop
Key to quit the Display function.
[Service Mode > Display}
Display Function Setting ‘
<Warm-up time>
Displays the warm-up time on the Display Panel.
<Current !U Counter count display>
<Display Example>
Displays the count of the current [U Counter on the Display
Panel.
<Previous |U Counter count display>
Displays the count of the previous IU Counter on the. Display
Panel.
<Display test>
Blinks all LEDs on the contro] panel other than the ready
Indicator.
The warm-up time and IU Counter count are shown on the Display Panel in the following order.
©® Warm-up time display
(Example : 46.50 sec.)
L@)-O-@-O-@)-O-@)-o4
e |U Counter count display
(Example ; 12034)
L@)-O-@-O-@-O-@-O4
S-9