Minolta EP1030 - Fusing Pressure and Exit Unit

1159SBM1902A c
19-2. Fusing Rollers Pressure Mechanism
Pressure Springs are installed at both ends of the Lower Fusing Roller. These
springs contact the bearings mounted on both ends of the Lower Fusing Roller and
exert pressure through the Lower Fusing Roller to the Upper Fusing Roller which
is installed in the Fusing Unit.
The Fusing Unit is divided into an upper and a lower half, and the upper half can
be swung open. The Upper Half of the copier, when locked in position, presses the
upper half of the Fusing Unit down onto its lower half.
Upper Copier Frame
Upper Fusing Roller
Pressure Spring Lower Fusing Roller
M-48
1159SBM2000A,
aon EXIT UNIT
The Paper Exit Roller/Rolls feed the paper, to which the developed image has been
fixed, out of the Fusing Unit onto the Copy Tray. The Charge Neutralizing Brush
touches the surface of the sheet of paper being fed out of the Fusing Unit to
neutralize any static charge left on it. The Upper and Lower Separator Fingers strip
the paper from the surface of the Upper/Lower Fusing Roller,
Paper Exit Roll
Charge Neutralizing Brush
Upper Séparator Finger
Paper Exit Roller
1159M013AA
1159SBM2001 A ;
20-|. Upper/Lower Separator Fingers
The Upper Fusing Roller is provided with two Separator Fingers which are laid out as
shown below.
Paper Path Reference Position
4159M048AA
M-49