Minolta EP1030 - Service Mode: Technician Settings; Tech. Rep. Choice Functions

1159SBS050402A
2. Tech. Rep. Choice
®@ This function allows the Tech. Rep. to make various settings and adjustments.
<Setting Procedure>
1. Select the Tech. Rep. Choice function. (“c1” appears on the Display Panel.)
2. Select the subfunction to be set or adjusted using the Copy Quantity and Zoom Key @ and press the
Start Key.
3. Change the set data as necessary using the Copy Quantity and Zoom Keys.
4. Press the Clear/Stop Key to validate the setting.
<Leaving the Function>
® Select the next Tech. Rep. Choice subfunction using the Copy Quantity and Zoom Key © or press the
Cleat/Stop Key to quit the Tech. Rep. Choice function. :
[Service Mode > Tech. Rep. Choice}
| ChoieeNo. | Setting (The defautt is EEEIEIEZE .)
<Marketing area>
The correct fixed zoom ratios and paper sizes are selected according to the
marketing area setting selected.
Perenpien
Note: Do not select “2” for this subfunction.
<IU control mode>
Select whether to use the copier or Tech. Rep. to keep track of the replace-
ment time of the IU.
the IU life by the IU life
Description IU control : Controlled by | PM control : Not controlled
Note. {U control = 1U Counter; PM control = CP Counter
<Auto Power OFF Disabling>
Select whether to enable or disable the Auto Power OFF that is to be acti-
vated after the lapse of a given period of time after a copy cycle has been
completed or a key pressed.
Description | 0 min
S-10
[Service Mode > Tech. Rep. Choice]
Setting (The defaultis [uehUeiced .)
<ATDC Detection Level>
Select the ATDC control level (T/C ratio).
Description Description
60 T/C ratio 6.0%
TIC ratio 4.0%
TiC ratio 6.5%
TIC ratio 4.5%
TIC ratio 5.0% T/C ratio 7.0%
T/C ratio 5.5%
Cholce No.
<Toner Empty Stop> ‘
Select whether or not inhibit copying when a toner-empty condition is
detected.
Description Inhibits copying. Permits copying.
<Data clear mode>
Select the type of settings that are to be reset to the initial values when the
power is next turned ON (except for resetting a misfeed).
Note that “machine setting” and “all counters” can be selected when the Auto
Exposure {AL indicators lit,
Description
Machine setting
All counters
CP counter
CP-related counters
Note: _ Enabled when “1” is set for Tech. Rep. Choice “c2.”
"Neen
scaeneantenmaenentitiemmenanes
sony
.,erwunenna™
S-11