Minolta EP1030 - Paper Take-Up Mechanism; Paper Separating Mechanism

1159SBM2101A
21-1. Paper Take-Up Mechanism
The semi-circular portions of the Paper Take-Up Rolls are in the upper position in the
standby state so that the rolls will not hamper proper loading of paper. When the Start
key is pressed, Multi Bypass Paper Take-Up Solenoid SL3 is operated to press the Pa-
per Take-Up Rolls against the paper stack for paper take-up.
In Standby At Take-Up
1159MO3OAA 1159MO30AA
Main Drive Motor M2
Start Key ee
SL OFF (Paper Take-Up Roi! DOWN) St. ON (Paper Take-Up Rol UP)
’
‘
. 0.3 Si
Paper Take-up Solenoid ON ; Approx Este
SL3 OFF
Approx. 0.5 a80 Approx. 0.5 866
Paper
Take-up
Clutch
ON
es
ee
Oe
ee
GES :OFF | Approx H | Approx
H 10.3000 | 10.3 se0
Transport Roller Sensor PC51
1st Sheet 2nd Sheet
of Paper f Pi
Ks renee 1188TOBMCA
Control Signal Energized | Deenergized WIRING DIAGRAM
sis_[pwearsee [1 | 4 | 10F
M-52
1159SBM2102A
21-2. Paper Separating Mechanism
The paper separating mechanism of the Multi Bypass Table uses a Paper Separator Pad
affixed to the Multi Bypass Table directly under the Take-up Rolls. It ensures that only
the top sheet of paper is fed in by properly separating the second sheet of paper from
the top one.
Paper Take-Up Roll
_
J159M032AA
Paper Separator Pad
M-53