Minolta EP1030 - SDH Unit Procedures; Removing the Paper Feed Roller;Pick-up Roller;Separator Roller

1158SBD0208A
2-8. SDH Unit (EP1030F/EP1031F Only)
(1) Removing the Paper Feed Roller/Pick-up Roller/Separator Roller
Swing down the Front Cover.
Release and swing up the Upper Half of the copier.
Remove three screws and the Rear Cover.
Remove the one Connector from the PWB-A.
Remove the one screw, one washer and the Ground Wire,
10. Remove the Hamess.
11. Remove the four screws and the Transport Guide Plate
Assy.
A PFON >
~
1189D117AC
12. Remove the three Collars and the Hamess.
13, Remove the three screws and free the PWB-C Assy.
14, Remove the two screws and free the Lead Switch Assy.
6. Openthe SDH and remove the one screw, one washer and
the Ground Wire.
1159D112AC
15. Remove the eight screws and the Transport Assy.
7. Remove the six screws and SDH.
16. Move the Bushing to the rear and remove the Paper Roller
8.
Remove
the
two
screws
and
Lower
Rear
SDH
Cover.
Assy.
NOTE
The SDH, left attached to the copier, can also be disas-
sembled.
1159D120AA
9.
Remove
the
three
screws
and
Lower
Front
SDH
Cover.
17.
Snap
off
the
one
E-ring
to
remove
the
Paper
Feed
Holder
Assy.
59D 116AA
1159D121AA
D-34 D-35