FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 GENERAL
98.04.24
G-11
1174SBG0300A
To ensure that the copier is used in an optimum condition, observe the following precau-
tions.
•
Never place a heavy object on the copier or subject the copier to shocks.
•
Insert the power plug all the way into the outlet.
•
Do not attempt to remove any panel or cover which is secured while the copier is making
copies.
•
Do not turn OFF the Power Switch while the copier is making copies.
•
Provide good ventilation when making a large number of copies continuously.
•
Never use flammable sprays near the copier.
•
If the copier becomes inordinately hot or produces abnormal noise, turn it OFF and
unplug it.
•
Do not turn ON the Power Switch at the same time when you plug the power cord into the
outlet.
•
When unplugging the power cord, do not pull on the cord; hold the plug and pull it out.
•
Do not bring any magnetized object near the copier.
•
Do not place a vase or vessel containing water on the copier.
•
Be sure to turn OFF the Power Switch at the end of the workday or upon power failure.
•
Use care not to drop paper clips, staples, or other small pieces of metal into the copier.
Operating Environment
The operating environmental requirements of the copier are as follows.
✽
Temperature: 10°C to 30°C with a fluctuation of 10°C per hour
✽
Humidity: 15% to 85% RH with a fluctuation of 10% RH per hour
Power Requirements
The power source voltage requirements are as follows.
3 PRECAUTIONS FOR USE
✽
Voltage Fluctuation:
✽
Frequency Fluctuation:
AC115/120/127/220/240V
±10% (Copying performance assured)
+6%, –10% (Only AC127V)
–15% (Paper feeding performance assured)
50/60 Hz ±0.3%
To Next Page
Loading...
