FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
D-25
(23 cpm copier)
Remark
Whenever the Scanner Drive Cable has been rewound, be sure to make the “Adjustment of
the Scanner/Mirrors Carriage Position.” See p. D-69.
(4) Winding of the Scanner Drive Cable
Pulley B
Pulley A
Scanner Drive Gear
Pulley C
1149D047AB
1. (With reference to the center of the entire length of
the cable) Wind one length of the cable 5 times
counterclockwise around the Pulley, starting with
the end of the D-cut on the pulley shank and work-
ing from the front to the back side. Then, secure
the cable with tape.
1149D038AB
2. Mount the Cable Drive Pulley on the Pulley Shaft
and fit the Support Plate.
1174D007AA
To Next Page
Loading...
