FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
D-23
3. Unhook the spring and remove the length of the
cable on the right (looking at the copier from the
rear).
1139D129AA
4. Move the 2nd/3rd Mirrors Carriage toward the
Scanner Drive Gear so that the cable slacks off
and then remove the length of the cable on the left
(looking at the copier from the rear).
5. Remove Master Board PWB-A (four screws).
1139D130AA
6. Remove Optical Section Cooling Fan Motor M2
(two screws).
7. Remove the ADF fixing bracket (one screw).
1149D035AA
8. Remove Scanner Motor M4 (three screws).
1149D036AA
9. Snap off the Support Plate and remove the Scan-
ner Drive Pulley.
1174D008AA
To Next Page
Loading...
