Tap a new Toner Bottle against a desk
or other hard surface four to five times.
Then, turn the Toner Bottle upside
down and tap it in the same way again.
3
1134O075AA
Shake the new Toner Bottle well.
4
1138O048AA
With the Seal facing upward, insert the
Bottle into position.
5
1136O005AA
Check that the marking on the
Bottle is aligned with the marking
on the Toner Bottle Holder.
Then pull the seal off the Toner Bottle.
6
1136O006AA
1136O007AA
Swing the Toner Bottle Holder closed
and close the Front Door.
7
•
Use ONLY the specified toner for this
copier. Using any other toner could
result in image trouble.
•
Do not turn OFF the Power Switch or
open the Door while the copier is
replenishing toner.
NOTES
Use the Toner Replenisher function
available from the User Mode if the
image is light immediately after the
Toner Bottle has been replaced with a
new one.
➭
p. 83
Toner Replenisher
Chapter 5
When a Message Appears
2. When the Message "Replenish Toner." Appears
109
To Next Page
Loading...
