Minolta IIIF - Setting Correction Values

Setting Correction Values
* Correction values cannot be set in memory channel 0.
1 Select the memory channel to set correction values in (p.19).
D Press and hold the memory (M) button. Either " LB” or
CC” will blink in the display to indicate which value can
be changed.
* To change the value which is not presently blinking, release the memory button, and then press it
again.
up/down control to set the correction value.
* Correction values will be added to the initial measurement
results to obtain the displayed measurement results.
3 While continuing to hold the memory button pressed, use the
* Correction values can be determined as follows:
a
b
20
Measure a test scene using the Color Meter DIE set to memory channel 0 (no correction)
and note the measurement results.
Take a series of color-bracketed test photographs, with the measurement results obtained
in (a) as the center of the color brackets.
Evaluate the photographs and select the one with the best color. The filtration used for
this photograph will then be used to determine the correction value. (If none of the test
photographs have exactly the right color, repeat (b) with the filtration used for the best
photograph as the center of the color bracket.)
Once an acceptable test photograph has been obtained, the LB correction value can be
determined by subtracting the LB index measured in (a) from the mired shift value of the
filtration used for the test photograph. The CC correction value should be adjusted
repeatedly until measurements under the conditions in (a) give values corresponding to
the CC filtration used for the test photograph.