Minolta IIIF - Flash Measurements; With a Sync Cord

Flash Measurements
WITH A SYNC CORD
L
2
14
Check that the film-type switch is at the correct position (p. 9), the desired display mode is
selected (p. 10), and the desired memory channel is selected (p. 19; if no memory channel
number is shown, the selected memory channel is 0).
Slide the measuring-mode switch to the “CORD” position.
“If the setting of the measuring-mode switch is changed,
the previously displayed values will disappear.
Set the flash-range switch according to the aperture which
would be used at the meter position: For apertures from f/2.8
to f/22, set the switch to Lo; for apertures from f/22 to f/180,
set the switch to Hi.
Use the up/down control to select the shutter speed to be used.
* Shutter speeds from 1 to 1/500 sec. can be selected in 1-stop
increments.
* Be sure that the shutter speed is set within the camera’s
X-sync range.
“The shutter-speed setting “F”, which is the setting above
1/500 sec., sets the meter to analyze mode (see p. 18).
TIME
ou