Minolta IIIF - Page 17

Attach the flash sync cord to the Color Meter IIIF’s sync terminal.
5 * The flash may fire when you attach the cord.
the measuring button; the flash will fire and a measurement
will be taken.
* The trigger voltage of some electronic flash units may be too
low for the Color Meter IIIF to fire them in cord mode. If this
is true of your flash, use non-cord mode (see p. 16).
6 Aim the Color Meter IIIF’s receptor toward the flash and press
* If the over-range indication ( @ } appears in the display and the flash-range switch is set to Lo,
set the switch to Hi. if the under range indication ( D ) appears and the flash-range switch
is set to Hi, set the switch to Lo. If either indication reappears, see p. 5.
` H ambient light is present, the measurement results will be the filtration required for the
combination of flash and ambient light. To obtain measurement results for only the light from
the flash, see p. 18.
* If the shutter speed is changed after measurement, the displayed values will be automatically
recalculated for the new shutter speed.
15