Minolta IIIF - Page 18

WITHOUT A SYNC CORD
selected (p. 10), and the desired memory channel is selected (p. 19; if no memory channel
1 Check that the film-type switch is at the correct position (p. 9), the desired display mode is
number is shown, the selected memory channel is 0).
* If the setting of the measuring-mode switch is changed, the
previously displayed values will disappear.
D Slide the measuring-mode switch to the “NON.C” position.
CT
would be used at the meter position: For apertures from f/2.8
to f/22, set the switch to Lo; for apertures from £/22 to f/180,
set the switch to Hi.
3 Set the flash-range switch according to the aperture which
TIME
30
* Shutter speeds from 1 to 1/500 sec. can be selected in
1-stop increments.
° Be sure that the shutter speed is set within the camera’s
X-sync range.
* The shutter-speed setting "E, which is the setting above
1/500 sec., sets the meter to analyze mode (see p. 18).
( Use the up/down control to select the shutter speed to be used.
LB
Dm
CC ?
me En N Lo
16