Minolta IIIF - Page 19

Press the measuring button” NON.C” will start blinking, indi-
cating that the Color Meter IHF is in stand-by mode, waiting
for the flash to be fired.
* Stand-by mode will be automatically canceled after 16 seconds
if no flash is fired. lf the measuring button is pressed while
the meter is in stand-by mode, the 16-second period will be
restarted.
Aim the Color Meter IIF's receptor toward the flash and fire the
flash. The measurement will be taken when the flash is fired |
and stand-by mode will be canceled CNON CT will stop CC
blinking). GA
TIME 5O
* If the over-range indication ( À )appears in the display and the flash-range switch is set to Lo,
set the switch to Hi. If the under range indication ( D ) appears and the flash-range switch
is set to Hi, set the switch to Lo. If either indication reappears, see p. 5.
* If ambient light is present, the measurement results will be the filtration required for the
combination of flash and ambient light. To obtain measurement results for only the light
from the flash, see p. 18.
* if the shutter speed is changed after measurement, the displayed values will be automatically
recalculated for the new shutter speed.
17