NOT TO BE USED FOR INSTALLATION PURPOSES.
CAT. 5910
page 6 of 10
RAX-LCD Remote Shared Display
The RAX-LCD Remote Shared Display is a remote
annunciator that provides the same functions as the
main display on the fire alarm control panel, less
the 16 zone LEDs. In addition to operating as a
remote annunciator, it can also be used as a driver
module for standard LED annunciation or reduced
zone annunciation (different from the main panel
annunciation), graphic drivers programmed different from
the main annunciators, programmable switch modules
with a unique conguration and fan damper control also
with a unique conguration. Each time a different type
of annunciation conguration is needed an additional
RAX-LCD is required. The RAX-LCD occupies one
display position in the BB-1000 or BB-5000 enclosures.
Remote Annunciators
RAX-1048TZDS Adder Remote LED Annunciator
The RAX-1048TZDS Adder Remote LED Annunciator
provides an additional 48 points of LED annunciation.
The RAX-1048TZDS is an expandible module that
connects to the RAM-1032TZDS. The RAX-1048TZDS
occupies one display position in the BB-1000 or BB-5000
enclosures.
RAM-1032TZDS Main Remote LED Annunciator
The RAM-1032TZDS Main Remote LED Annunciator
provides common annunciator functions and 32 points of
LED annunciation. Each display point can be identied
by the slide-in label that slides in beside the LED. The
RAM-1032TZDS is equipped with sealed membrane-
like buttons for Common Control functions. The RAM-
1032TZDS allows for the control switches to be disabled
on a per function basis for areas that do not require
certain common control functions to be remotely located
from the re alarm control panel. The RAM-1032TZDS
can be programmed differently than the main panel
annunciator or a remote RAX-LCD. All RAM-1032TZDS
remote annunciators on the system must be programmed
the same. The RAM-1032TZDS occupies one display
position in the BB-1000 or BB-5000 enclosures.
MGD-32 Master Graphic Driver Module
The MGD-32 Master Graphic Driver Module provides
common control inputs for the common control switches
such as System Reset, Signal Silence, Auxiliary
Disconnect, Fire Drill, Lamp Test, Acknowledge and
General Alarm. Any or all of these switch inputs can
be used. There are supervised outputs for all of the
support LEDs and the common control switches. The
MGD-32 can also drive up to 32 supervised outputs.
These output points are capable of driving LEDs or
incandescent lamps. Mounts in a graphic annunciator
wallbox or in the BB-5000 enclosures. External power
supply required for incandescent lamps and lamp
test.
Graphic Annunciator Driver Modules
AGD-048 Adder Graphic Driver Module
The AGD-048 Adder Graphic Driver Module can be used
with the MGD-32 Master Graphic Driver modules, or
if located remotely it must be connected and mounted
with the RAX-LCD Shared Display. The AGD-048 will
support an additional 48 supervised outputs. As with
the master modules, the AGD-048 will support both
LEDs and incandescent lamps. Mounts in a graphic
annunciator wallbox or in the BB-5000 enclosures.
NOTE:
The combined total of RAM-1032TZDS and MGD-32 per
system is eight. All RA-1000 Series annunciators or Graphic
driver modules must have the zoned LED or graphic LED
correlated to the same combination of addressable devices
or hardwired zones . However, the zoned LED annunciator
on the FX-2000 main panel can be programmed differently
from the annunciators mounted remotely.
To Next Page
Loading...
Need help?
General
