Page 52
NOTE: Any time the parameters above are changed, the system must be reset, by chosing the options
menu and selecting reset. Parameters such as DTMF Values, Timers and Password.
[MM/DD/YYYY][HH:MM]
[__/__/____][__:__]
Date: 08/10/1999
Time: 10:42:33
Please remember to Initialize Logging before operating this feature.
Log data not present
0001 08/10/99 10:42
4321D Acc: Yes
Place arrow on Set Time and Date and press 0 and the next screen will be:
Enter month, for example August as ‘08', day ‘10', year ‘1999' and the hour and minutes. Press # to go back to
programming menu. NOTE: The TAS 2000 is Y2K compliant.
Show Time and Date
Place arrow on the Show Time and Date function and press 0 and the next screen will be:
Press # to go back to programming menu.
Show Logging
Place arrow on Show Logging and press 0 and the next screen will be:
This message will arise if the system has just be installed, if events have occurred such as dial codes entered and
doors opened; all this information will be listed with date and time. See below for example:
The first four digits represents the index of logged events in sequence form 1 (0001) and up to 1000. The next
digits 08/10/99 represents the date as month, day and year. Following is the time in hour and minutes. The second
line shows the 4 digit code dialed to get entrance. The following letter is D= for dial code or K=keyless code. Acc:
represents access and followed by Yes or No depending if access was granted or not.
To Next Page
Loading...