Operation Manual Getting Started
1-1
1. SAFETY - WARNINGS AND PRECAUTIONS
Read ALL Instructions Before Installing or Using Equipment
Your new Ultrasonic Liquid Processor has been designed, built and tested to assure
maximum operator safety. However, no design can completely protect against improper use
that may lead to bodily injury and/or property damage. For total safety and equipment
protection, read the instruction manual carefully before attempting to operate this equipment.
Observe the following WARNINGS:
• High voltage is present in the generator (power supply), convertor and high frequency cable.
There are no user-serviceable parts inside any of these devices. Do NOT attempt to remove
the generator cover or convertor case.
• Do NOT touch any open cable connections on the unit while the power is turned ON.
• Do NOT operate generator with convertor disconnected from high voltage cable. High
voltage is present in the cable and may pose a shock hazard.
• Do NOT attempt to disconnect the convertor high voltage cable while the unit is Running.
• The generator must be properly grounded with a 3-prong plug. Test electrical outlet for
proper grounding before plugging in unit.
• Install the SONICATOR
®
in an area free from excessive dust, dirt, explosive or corrosive
fumes and protected from extremes in temperature and humidity.
• NEVER immerse the convertor in liquids of any kind, or let condensed moisture or liquid drip
into the convertor.
• NEVER grasp an activated horn or touch the tip of a vibrating probe. It can cause severe
burns and tissue damage.
• NEVER hold or clamp the convertor by the front driver (black portion) or by the horn itself.
This can cause permanent damage to the system. Support the convertor by only clamping
around the convertor case.
• Do NOT allow the tip of a vibrating horn or probe to touch the counter top or any other hard
surface. It could damage the probe, overload the generator, or damage the surface.
• Avoid touching the bottom or sides of a glass or plastic container with an activated probe. It
could crack or shatter the glass or melt the plastic.
• Turn OFF the power switch, unplug the generator and disconnect the power cord from the
back of the generator before attempting to replace the fuses.
To Next Page
Loading...
Need help?
General