Operation Manual Getting Started
2-1
2. GETTING STARTED
Inspections
Your new SONICATOR
3000 Ultrasonic Liquid Processor was thoroughly inspected, tested and carefully
packed before leaving the factory. Prior to unpacking, carefully inspect the shipping carton for any evidence
of damage. Claims for loss or damage sustained in transit, must be made to the shipping company.
Unpack the unit from its shipping carton and check the contents against the packing list. Before disposing of
the packing material, check it carefully for small items. Report any missing components to Misonix
immediately.
Visually inspect all external controls, indicators and surfaces to detect any damage in transit. If damage has
occurred, contact your carrier within 48 hours of delivery date. DO NOT OPERATE DAMAGED EQUIPMENT.
Retain all packing materials for possible future shipments.
Power Requirements
For power requirements, check the label on the back of the unit.
1. For 100V operation, the generator requires a single phase, three wire, 100V, 50/60 Hz
line supply, unless otherwise specified.
2. For 120V operation, the generator requires a single phase, three wire, 120V, 50/60 Hz
line supply, unless otherwise specified.
3. For 220V operation, the generator requires a single phase, three wire, 220V, 50/60 Hz
line supply, unless otherwise specified.
WARNING!!
The electrical line cord is equipped with a 3-prong grounding plug. Do not, under any
circumstances, remove the grounding prong. The plug must be plugged directly into a mating
3-prong grounding type outlet.
Placement of Equipment
Place the Generator in an area that is free from excessive dust, dirt, water and explosive or
corrosive fumes. A fan maintains safe operating temperature in the generator by circulating air over
the electronic components. Therefore, the generator must be placed so that the air intake grills on
the rear and lower panels are not blocked. DO NOT place unit on a soft surface such as a towel or
foam, which may compress and block the lower grill. Place unit on a hard smooth surface only.
Clean and inspect the air intake grill periodically, to insure it is free from dust and debris.
To Next Page
Loading...
Need help?
General