MITECH MICRO 8 - Introduction; Features and Non-Detection Zones

MICRO 8
Installation and user manual
Page 10 of 24
The microwave device consists of two TX and RX units to be positioned at opposite ends of the
protected area. The TX unit emits electromagnetic waves in the direction of the RX unit that
receives them, processes them and translates them into an electrical signal that is analyzed.
The intruder who crosses the detection area (ZR) causes a change in the signal. The intensity and
type of signal depend on the following factors,
size and mass of the intruder who crosses the ZR,
speed and time of crossing the ZR, conformation and soil conditions
Techinical
features
Maximum
range
200 m
Detection
speed
from
0,1 to 10,0 m/s
Power
supply
from
12 to 36 Vdc
Consumption
module
TX 70 mA - module RX 110 mA
Recovery time after alarm notification
10
s
Duration
of the report
5 s
Operating
frequency
from 24.000 to 24.250 GHz (K band)
Selectable
frequencies
By
dip-switch: 16 - by software: 250
Maximum lobe height
2,5 m
Maximum
lobe aperture
50 m range: 0,6 m at 25 m
100 m range: 1,2 m at 50 m
200 m range: 2,4 m at 100 m
Installation height
From 80 to 90 cm from the ground
Standard compliance
EN 50131
-1 and CEI 79-3
ROhs
compliance
2011/65/UE
Protection class
IP
65
Warranty
3 years
3,0 m
20 cm
2,0 m
50 cm
1,0 m
70 cm
90 cm
Non
-detection zones
Microwave device