MITECH MICRO 8 - Default Chapter; Table of Contents

MICRO 8
Installation and user manual Page 2 of 24
Index
Introduction
and warnings
Page 3
Components
Page 4
•
Wall installation ……………………………………………………………………………………………………………………. 5
•
Wall installation with MICRO BOX …………………………………………………………………………………………. 6
•
Pole installation …………………………………………………………………………………………………………………….. 7
•
Pole installation with MICRO BOX ………………………………………………………………………………………….. 8
•
Horizontal and vertical orientation ………………………………………………………………………………………… 9
Microwave
device Pages
from 10 to 20
Notes
Pages
from 22 to 23
•
Introduction …………………………………………………………………………………………………………………………… 10
•
Features and non-detection zones …………………………………………………………………………………………. 10
•
Receiver board (RX ) …………………………………………………………………………………………………………….... 11
Description of dip switch and terminal board
•
Transmitter board (TX ) …………………………………………………………………………………………………………… 12
Description of dip switch and terminal board
•
Installation ……………………………………………………………………………………………………………………………… 13
•
Manual configuration by dip-switch ……………………………………………………………………………………….. 13
RX module - signal sensitivity setting
RX module - setting of the signal attenuation time
TX module - setting of 4dB transmission signal attenuation
•
Control through software (RS485) …………………………………………………………………………………………… 15
Description of columns and parameters modification
Columns READ - WRITE - REAL TIME
Connection options via RS485-USB adapter
Warnings
Page 20
Product
photos
Page 21
Mounting
options Pages
from 5 to 9