Mitel 112 Quick Reference Guide

QUICK REFERENCE GUIDE
© Copyright 2015, Mitel Networks Corporation. All Rights Reserved.
The Mitel word and logo are trademarks of Mitel Networks Corporation.
Any reference to third party trademarks are for reference only and Mitel makes no representation of the ownership of these marks.
QUICK REFERENCE GUIDE
Call Handoff
If your handset is twinned to your desktop phone via a personal ring group, you can use the call handoff
feature. This feature allows you to “push” an active call from your desktop phone to your handset, or “pull”
an active call from your handset to your desktop phone. You active call handoff by pressing a Handoff
feature key on your desktop phone. To program a Handoff feature key, refer to your phone’s user guide for
instructions.
To push a call to your handset
• While on a call at your desktop phone, press the Handoff key. The call is transferred to your handset.
• Press to continue the call on your handset.
To pull a call to your desktop phone
• While on a call on your handset, press the Handoff key on your desktop phone.
• The call is presented on your desktop phone in handsfree mode. Lift the desktop phone handset to
continue the call using your desktop phone.
Troubleshooting
Symptom Possible Cause Corrective Action
Handset display is black. Handset is in power saving mode. Press any key.
Batteries drained. Put handset in charging cradle to re-
charge.
Handset does not charge. Power to handset charging cradle is
not connected.
Ensure that power cable is connect-
ed to wall outlet.
Batteries are not inserted correctly. Check that the batteries are inserted
correctly.
Battery life is exceeded and they no
longer accept charge.
Obtain replacement batteries and re-
place.
Cannot enable features
using Feature Access
Codes.
Feature is not enabled for your
handset.
Contact your System Administrator
and ask to have the feature enabled
for your handset.
System does not use default Fea-
ture Access Codes.
Contact your System Administrator
for a list of the supported Feature Ac-
cess Codes for your system.
Calls are not ringing the
handset.
A feature such as Call Forwarding
Always is enabled that prevents
your handset from receiving calls.
Enter the Clear All Features Access
Code (Default Code is ∗77)

Mitel 112 Specifications

General

Protocols	SIP
Lines	2
Headset Port	Yes
Volume Controls	Yes
Speakerphone	Yes
Wall Mountable	Yes
Ethernet Ports	2 x 10/100 Mbps
Power	PoE