Installation and first-time operation
Mitel 622 DECT Phone 101
eud-1720/1.0 – R3.0 – 08.2015
Battery
Take also note of the safety information on handling the battery set out in chapter
"Dealing with batteries", page 7.
Inserting the standard battery
1. Push the battery cover downwards until it is released from the lock, then take it off.
2. Insert the battery with the contacts downwards.
3. Replace the battery cover and push it upwards until it locks.
Inserting the power battery
The power battery has a larger capacity and is available as an option. Its design is thicker,
which means a larger battery cover is required, protruding by approx.6 mm on the back of
the phone.
1. If necessary, remove the fitted clamp.
2. Fit the battery cover as described for the standard battery.
To Next Page
Loading...
