46 Mitel 622 DECT Phone
eud-1720/1.0 – R3.0 – 08.2015
Supplementary features
Recording a call
You want to record an active call with your call partner.
You can record an active conversation if you have been authorized to do so by your sys-
tem administrator
[b]
. Your call party can be an internal or an external user. The recordings
are made and backed up only as .wave files in your individual e-mail boxes. For this, you
must configure at least one e-mail address in the communication system. Contact your
system administrator for more information.
You can start recording calls in the following situations:
• during an active call;
• During a conference call (with maximum two participants)
• During an incoming/outgoing call
• in call preparation;
• During dialling with a busy line.
Call recording only starts when the connection is set up. Therefore, no ring-back tones or
wait tones are recorded.
Call recording is temporarily interrupted during an enquiry and an e-mail is sent with the
recording made up till then. Recording restarts automatically once the call connection with
the enquiry call party is set up and/or once the call connection with the first correspondent
is restored.
The maximum recording time for each .wave file depends on the system configuration.
When the predefined or maximum recording time is reached, the recording stops auto-
matically, the file is sent to your e-mail address and a new recording starts at the same
time. Contact your system administrator for more information.
Park
Press the Park softkey.
➔Your call partner is now parked locally; is displayed.
Take back
To retrieve a parked call party:
Press the Take back softkey.
Notes:
• With the End key the display returns to the idle state. As long as your
call partner does not hang up, he remains parked. You can retrieve
your parked call party using Menu > Activated features > Take back.
• The function code for central parking can be found in the User Guide
Function Codes on the
Mitel DocFinder.
To Next Page
Loading...
Need help?
General
