Mitel 622 DECT - Page 58

58 Mitel 622 DECT Phone
eud-1720/1.0 – R3.0 – 08.2015
Supplementary features
Suppressing your call number from your called party's terminal
display
You do not want your call number to appear on the terminal display of a called party in the
public network.
You have two possibilities:
• If you never want the phone number to be displayed, set CLIR Permanent.
• To suppress your call number display for certain calls only, select the functionCLIR Per
call before dialling your party's call number.
This function must be stored under a function key (see chapter
"Configuring keys",
page 91).
You can also execute the function with a function code (see User Guide Function Codes
on the Mitel DocFinder).
<Function code>
Or:
1. Enter function code #46 for a private call.
2. Enter your internal phone number.
3. Enter your PIN.
4. Enter the external call number directly, without the exchange access
digit.
5. Press the Call key.
➔The phone is now enabled; the external user is called.
Note:
The default PIN setting "0000" is not accepted. First change the PIN as
described in chapter
"Changing the User PIN", page 82 or use the func-
tion code *47 (see User Guide Function Codes on the
Mitel DocFinder).
If you have forgotten your PIN, your system administrator can reset it to
the default setting.
CLIR
Before the call:
Press the function key for CLIR.
Notes:
• CLIR works only with external calls.
• This feature depends on the range of services offered by your provider.