To Next Page

To Previous Page

Configuring the fax server

Applications Card CPU2-S

syd-0620/1.1 – R4.0 – 01.2016

Placeholders for fax cover pages

Instructions on how to set up the fax service on the communication

server

You can only set up the fax service in expert mode.

To set up the fax service on the communication server via a digital network in-

terface (ISDN/CAS or SIP), proceed as follows:

1. Set up the fax server in the current view and upload the cover pages you

want to use.

2. If you are not yet in expert mode, change to expert mode now.

3. Create the DDI numbers for receiving fax messages and assign the fax

server as their routing destination (Configuration / Routing / DDI numbers

view, Routing destination = Fax server setting).

4. Check that the settings for the DDI interpretation are correct (Configuration

/ Routing / Trunk group view, Base number setting and DDI prefix setting).

5. Check the user settings to make sure an e-mail address is entered for all

the intended destination users (Configuration / User view).

6. Select a fax number for each intended destination user and assign each of

them the cover page you want Multimedia, Fax mailbox / Fax number and

Cover page setting).

7. Check the terminal settings of the connected Group3 fax devices to make

sure the Fax device setting is set to a value other than No fax device (Con-

figuration / Terminals view).

Placeholder Information

@@SENDERNAME@@ Name of the sender

@@FAXORIGINATOR@@ Fax DDI

@@SMTPORIGINATOR@@ E-mail address of the sender

@@RECEIVER@@ Fax number

@@SUBJECT@@ e-mail subject

@@BODY@@ e-mail content

@@DATE@@ Date of the fax transmission

@@TIME@@ Time of the fax transmission

Mitel 6930 SIP Installation Guide

Other manuals for Mitel 6930 SIP