Mitel 6930 SIP - Using Further Functions

Phoning
Mitel 6930 SIP 53
eud-1764/2.1 – R6.0 – 10.2018
You cannot reject silent intrusion (but you can block it; see chapter "Pro-
tecting yourself against calls", page 88). The microphone of the third user
remains off. The third user can, however, enter the conversation at any
point by enabling his or her microphone or pressing the intrusion function
key.
You must save this function to a configurable key using Self Service Portal
(see chapter "
Configuring or deleting a key assignment", page 94).
Notes: • Silent intrusion must be enabled in the communication system.
• Your system administrator must grant you silent intrusion rights.
• Silent intrusion may infringe on your national data protection provisions
or be permitted only under certain circumstances. If you intend to use
this function, you should therefore notify your call party in advance.
Using further functions
This section explains some more convenient features provided by
your phone. All functions you can save under a configurable key can
be found in chapter "Overview of available functions", page 59.
Activating personal call routing
You want to specify which of your phone shall ring when you receive a call.
You can specify the phone on which a call is signaled with personal call
routing.
Your system administrator set up multiple phones with the same phone
number in the one number user concept for you (see chapter"One number
user concept", page 8). The system administrator has also assigned you
Activating silent intrusion (the users are talking):
1. Press the function key for Silent intrusion.
2. Enter the call number of the user you want as per the key configuration.
➔The function is activated.
➔If the user has blocked intrusion, connection set up will be cancelled.
Answering silent intrusion:
There are neither display nor sound signals on your phone to indicate silent
intrusion.