Mitel 6930 SIP - Page 55

Phoning
Mitel 6930 SIP 55
eud-1764/2.1 – R6.0 – 10.2018
Activating Ring Alone
You want to specify the phone on which an incoming call is signaled
acoustically.
If your system administrator has set up one phone number for several
phones (see "
One number user concept", page 8),you can use Ring Alone
to define on which phone a call will be signaled acoustically. As soon as
you activate Ring Alone on one phone, the ring tone is deactivated for all
other phones. An incoming call is signaled in the display of all phones. You
can answer the call on any of the phone; once the call is answered, other
phones go back to the idle state.
You must save this function to a configurable key using Self Service Portal
(see chapter "
Configuring or deleting a key assignment", page 94).
Note: When you have activated ring alone but deactivated the personal call rout-
ing for a phone in parallel, an incoming call is not acoustically but only
visually signaled.
Locking/Unlocking your phone
You need to leave your desk and want to ensure that no-one can alter your
phone's settings, look at your private data, or make calls from your phone.
You can lock your phone with a 2 to 10-digit PIN (for more information on
the PIN, see chapter "
Changing the PIN", page 86).
You must save this function to a configurable key using Self Service Portal
(see chapter "Configuring or deleting a key assignment", page 94).
Press the function key for the desired call routing profile.
➔Call routing is activated/deactivated, LED of the function key is switched
on/off.
Activating/deactivating ring alone
Press the function key for Ring Alone on/off.
➔Function is activated/deactivated, LED on the function key is switched on/off.