Mitsubishi Electric FX5 - PWM Output Function Execution Procedure

288
24 HIGH-SPEED INPUT/OUTPUT FUNCTION
24.7 PWM Function
PWM output function execution procedure
The procedure for executing the PWM output function is explained below.
1. Check the specifications of PWM output.
Check specifications such as pulse output performance of PWM output. (Page 286 PWM output specifications)
2. Connect the CPU module to the external device.
For details on wiring to external devices, refer to the following manual
MELSEC iQ-F FX5U User's Manual (Hardware)
MELSEC iQ-F FX5UC User's Manual (Hardware)
3. Set the parameters.
Set the output destination, cycle, pulse width, output pulse logic, etc. of the PWM in parameters, (Page 289 PWM output
parameters)
4. Create the program.
Create the program for using PWM output.
5. Run the program.