Mitsubishi Electric FX5 - PWM Output Parameters

24 HIGH-SPEED INPUT/OUTPUT FUNCTION
24.7 PWM Function
289
24
PWM output parameters
This section explains the PWM output parameters.
Set the PWM output parameters in GX Works3.
Outline of parameters
PWM output parameters are output destination, pulse width/cycle unit, output pulse logic, pulse width, and period.
Parameter setting
This section explains how to set the PWM output parameters.
Set the output destination, pulse width/cycle unit, output pulse logic, pulse width, period, etc. of the channel to be used.
■CPU module
Navigation window  [Parameter]  [FX5UCPU]  [Module Parameter]  [High Speed I/O]  “Output Function" 
“PWM"  "Detail Setting"
Window
Displayed items
Item Description Setting range Default
Use PWM Output Set whether to use PWM output or not. • Disable
• Enable
Disable
Output Signal Set the output destination device of output signal. Y0 to Y7 
Pulse Width/Cycle Unit Set pulse width/cycle unit. • 1ms
• 1micro-s (μs)

Output Pulse Logic Sets output pulse logic. • Positive Logic
• Negative Logic

Pulse Width Sets the ON/OFF width of the pulse. • When pulse width/period unit is set to 1 ms
1 to 2147483 ms
• When pulse width/period unit is set to 1 micro-s
(μs)
1 to 2147483647 micro-s (μs)

Cycle Sets cycle. • When pulse width/cycle unit is set to 1 ms
1 to 2147483 ms
• When pulse width/cycle unit is set to 1 micro-s
(μs)
1 to 2147483647 micro-s (μs)
