Revision History
Date of revision Manual No. Revision details
Jul. 1997 BNP-B2201* First edition created.
May 2000 BNP-B2201B(C) Addition (modification)
• Addition or modification of M64 additional parameters and alarms
• Addition of M65 and M66 parameters and alarms
• Correction of parameter names
Sept. 2001 BNP-B2201D
• The contents revised to correspond to M64AS, M64S, M65S and M66S.
• Miswrite is corrected
• Design of the cover and the back cover were changed.
• Manual name changed from "MELDAS 64/65/66 Alarm/Parameter Manual" to
"MELDAS 60/60S Series Alarm/Parameter Manual".
• MODEL, MODEL CODE, and Manual No. were added on the back cover.
Apr. 2002 BNP-B2201E
• Revisions to comply with M60S Series Version B0
• Mistakes corrected
Feb. 2003 BNP-B2201G
• Servo alarm and spindle alarm names were standardized.
• Servo parameters were overall reviewed. (Chapter 7 to 9 → Chapter 7)
• Revisions to comply with M60S Series Version B3
• Mistakes corrected.
May 2004 BNP-B2201H
• Revised to comply with M60S system software versions C0, C1.
Jun. 2005 BNP-B2201J
• Revised to comply with M60S system software versions C5.
Dec. 2009 BNP-B2201L
• Corrected the items below.
-#1284 ext20 bit0: Spindle speed clamp check
-P134 G96 G96 Clamp Err.
-M01 1043 No spindle speed clamp
• Corrected the mistakes.
To Next Page
Loading...
Need help?
General
