Mitsubishi Electric MELSEC iQ-R Series - Page 141

5 INSTALLATION AND WIRING
5.8 Mounting/Removing a Module or Terminal Block
139
5
Installation procedure
■ Installing an 18-point screw terminal block
After installing the terminal block, tighten two terminal block mounting screws.
■ Installing a spring clamp terminal block
1. Remove the protective cap from the Q6TE-18SN.
2. Install the Q6TE-18SN to the module and tighten the
terminal block mounting screws. (tightening torque: 0.66
to 0.89Nm)
(1)