Mitsubishi Electric MELSEC iQ-R Series - Setting Procedure

162
APPX
Appendix 5 How to Use MELSEC-Q Series Modules
Setting procedure
This section describes the setting procedure for the MELSEC-Q series module in GX Works3.
*1 When the CPU module used can be connected to GX Works3, the actual system configuration can be read out by selecting [Online] 
[Read Module Configuration from PLC] in the menu. For the modules which cannot be read out, create the module configuration by
dragging and dropping each module from "Element Selection" window.
*2 When "Points", "Start XY", or "CPU Module Operation Setting at Error Detection" are changed, set the parameters in "System
Parameter". (Page 158 Parameter items)
1. Create the module configuration in accordance with
the actual configuration by dragging and dropping
each MELSEC-Q series module from the "Element
Selection" window of "Module Configuration" in GX
Works3. Then, select [Edit]  [Parameter]  [Fix].
* 1*2
2. Set the module parameters of each module.
[Navigation window]  [Parameter]  [Module
Information]  Module model name  [Module
Parameter]