Mitsubishi Electric MELSEC iQ-R Series - Page 40

38
1 SYSTEM CONFIGURATION
1.1 Overall Configuration
■ CC-Link IE Field Network
When placing a module on the "Module Configuration" window or adding a module from the "Navigation window", select a
proper model with the engineering tool depending on the application.
Select a model name for the remote head module at project creation.
Window
RJ71GF11-T2(LR), RJ71GF11-T2(MR), and RJ71GF11-T2(SR) are model names on the engineering tool for
using the RJ71GF11-T2 in a redundant system. (Equivalent model names have been prepared for remote
head modules.)
(LR), (MR), and (SR) of the model names are abbreviations as follows.
• LR: Line Redundant
• MR: Master Redundant
• SR: Slave Redundant
Module Model Application
CC-Link IE Field Network master/local module RJ71GF11-T2 When not used in a redundant system
RJ71GF11-T2(LR) Redundant line
RJ71GF11-T2(MR) Redundant master station
RJ71GF11-T2(SR) Redundant slave station
Remote head module RJ72GF15-T2 When the remote head module is not used in a
redundant system
RJ72GF15-T2(LR) Redundant line
RJ72GF15-T2(SR) Redundant slave station
• Project creation • "Element Selection" window of "Module Configuration" (CC-Link IE Field
Network master/local module)
• "Element Selection" window of "Module Configuration" (Remote head
module)