Mitsubishi Electric MELSEC iQ-R Series - Page 74

72
2 ASSIGNMENT FOR MODULES
2.2 I/O Numbers of Modules
• To set the module reserved for future use, or when an already set module is not to be mounted, perform the module status
setting. ( Page 74 Module status setting)
• I/O numbers in the actual system I/O numbers of the module on slot No.5, which is not
set in the engineering tool, are assigned following the
I/O numbers of the module on slot No.4. This results
in an overlap of I/O numbers.
Set the I/O numbers of the module on slot No.5 in the
parameter so that they do not overlap.
CPU 0 1 2 3 4
5 6 7 8 9 11 1210
00
to
0F
10
to
1F
20
to
2F
40
to
4F
30
to
3F
Number of points
I/O number
40
to
4F
16 16 16 16 16
16