Mitsubishi Electric MELSEC iQ-RJ71C24-R4 - Page 553

APPENDICES APPENDIX
Appendix 7 When Connecting the Module to a Remote Head Module
551
A
7. Set the refresh settings as follows.
[Navigation window]  [Parameter]  [Module Information]  [RJ71GF11-T2]  [Module Parameter]  [Basic Settings]
 [Refresh Setting]
8. Write the set parameters to the CPU module of the master station on CC-Link IE Field Network. Then, reset the CPU
module or power off and on the system.
[Online]  [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameters, refer to
the following.
MELSEC iQ-R CC-Link IE Field Network User's Manual (Application)