6 - 30
6 PARAMETERS FOR POSITIONING CONTROL
6.4.2 S-curve ratio
S-curve ratio can be set as the acceleration and deceleration processing method for S-
pattern processing.
Setting range of the S-curve ratio is 0 to 100[%].
If it is set outside the range, an error occurs at the start and control is executed with the
S-curve ratio set as 100[%].
Errors are set in the error item information area (D9190).
Setting of the S-curve ratio enables acceleration/deceleration processing to be
executed gently.
The graph for S-pattern processing is a sine curve as shown below.
Positioning speed
Sine curve
0
Acceleration
time
Deceleration
time
Time
t
V
As shown below, the S-curve ratio setting serves to select the part of the sine curve to
be used as the acceleration/deceleration curve.
A
B
B/2 B/2
Sine curve
S-curve ratio = B/A 100%
A
B
Positioning speed
B/A=1.0
V
t
Positioning speed
V
A
B
B/A=0.7
S-curve ratio is 100[%]
S-curve ratio is 70[%]
t
(Note) : When the G00, G01, G02, G03, G12, G13 or G32 including M-code is used,
S-curve ratio is ignored and control is executed as always 0[%].
To Next Page
Loading...
