Mitsubishi Electric Q172CPU - Page 289

7 - 28
7 MOTION PROGRAMS FOR POSITIONING CONTROL
[Example]
<Command address 1>
G91;
#@10:L=1.;
G0 X#@10:L ;
The travel value of X is any of the following values.
mm inch degree
1 mm 0.1 inch 0.1 degree
<Command address 2>
G91;
#@10:F=1.;
G0 X#@10:F ;
The travel value of X is equivalent to any of the following
values if it is "#@10F=1.;" (64-bit double precision real
number).
mm inch degree
1 mm 0.1 inch 0.1 degree
<Feed speed (F) 1>
G91;
#@10:L=1.;
G01 X10.F#@10:L ;
The feed speed (F) of X-axis is any of the following
values.
mm inch degree
100 mm/min 10 inch/min 10 degree/min
<Feed speed (F) 2>
G91;
#@10F=1.;
G01 X10.F#@10F ;
The feed speed (F) of X-axis is equivalent to any of
the following values if it is "#@10F=1.;" (64-bit
double precision real number).
mm inch degree
100 mm/min 10 inch/min 10 degree/min